Order Deprovisioning and Cancelation

Order Deprovisioning and Cancelation

This topic lists the procedures to deprovision an installed device and to cancel an order.

Deprovisioning a device

The following scenarios require the deprovisioning of a device and order cancellation in the Adaptiv | Cloud Portal. 

  • Customer cancels a site after installing the Edge device

  • An order is provisioned, but installation is canceled 

  • Incorrect provision of a device

Information

After the cancellation of an order, the Edge device is deprovisioned and then reset to the factory default. Moreover, the IP address assigned to this device is released.

  1. Navigate to the Order Management tab and search for the order.
    Orders having one of the following statuses can be deprovisioned - PreConfig, Pre-Config Confirm, Install, Calibration, and Complete.
  2. Click  in the Action column.
  3. Click Yes, start deprovisioning! to begin deprovisioning.
  4. On the Order Deprovisioning page, click Deprovisioning.
    To deprovision a device but use an already assigned IP address for the reinstallation of the device, select the Skip Delete IPAM checkbox. 
    For example, if there is a requirement to replace the Edge device or change a configuration on the same device. 

  5. After the order is successfully deprovisioned, click Back to order view.

Deleting an order

You can delete only Open status orders.

  1. Navigate to the Order Management tab and search for the required order.
  2. Click  in the Action column.
  3. Click Yes, delete it! to delete the order.

Reopening an order

Orders in the Cancelled state can be reopened. As you reopen, the order status changes to Open and it can be edited.

  1. Navigate to Order Management tab and search for the required order.
  2. Click in the Action column. On the VIEW ORDER DETAILS page, click Reopen.

TERMS OF USE   |   ANTI SPAM   |   PRIVACY POLICY   |   USER LICENSE AGREEMENT   |   PATENTS

Copyright © 2026 Adaptiv Networks, Inc. Send Feedback