---
title: "Network Interfaces"
id: "network-interfaces"
project: "SC//Connect™ | OS v8.5"
url: "https://docs.scalecomputing.com/articles/sc-connect-os-v8-5/network-interfaces"
updated: 2026-11-19T17:09:11Z
---

# Network Interfaces

The **Network Interfaces** section displays the configuration and status of network interfaces on the device. It provides essential details for managing and monitoring interface connectivity. This section is divided into two sections: **Manual Interface Configuration** and **Interface Status**.

![](/resources/Storage/sc-connect-os-v8-5/network-interfaces/network-interfaces-2026-10-19-1.png)

## **Manual Interface Configuration**

The **Manual Interface Configuration** table displays manually configured interfaces with their properties.

* **Name** – The name of the interface, e.g., wan1.
* **Paused** – Indicates whether the interface is paused or active.
* **Mode** – Defines the mode of interface, which can be DHCP or static depending on the configuration of the internet links on the orchestrator.
* **Interface Types:**
    * **PPPoE** (Point-to-Point Protocol over Ethernet) – Connection requiring authentication (username/password).
(Note: PPPoE is not currently supported in the SC//Connect™ Orchestrator yet and it should be configured locally on the device or via MyCLI.)
    * **Mobile** (3G/4G/5G) – Cellular networks.
    * **IPv4 Static** (Internet Protocol version 4 Static) – Manually configured IP Address .
    * **IPv4 DHCP** ( Internet Protocol version 4 Dynamic Host Configuration Protocol) – Device will receive an IP Address from a DHCP server.

* **Outside** – Specifies if the interface is external (WAN interface).
* **Download/Upload Speed** – Shows bandwidth configuration in Mbps as configured on the orchestrator.
* **Weight** – Represents the interface preference metric used for local breakout balancing, not for traffic going through the tunnel.
* **Private** – Indicates a WAN link but not necessarily an Internet link, MPLS is the most common case.
* **Edit** – Click on Edit button opens the following menu.
This configuration menu allows users to modify the settings of the internet links. However, it is important to note that any changes made here will be overwritten by the configuration pushed to the device from the SC//Connect™ Orchestrator.
![](/resources/Storage/sc-connect-os-v8-5/network-interfaces/network-interfaces-2026-10-19-2.png)

The primary purpose of this configuration is during the initial setup of the device, particularly in scenarios where only static links are available. In such cases, this local configuration panel enables users to configure to configure the static link, allowing the device to establish a connection with the API server. Once connected, the device retrieves its full configuration from the orchestrator for proper deployment during the first boot or deployment phase.

## **Interface Status**
The **Interface Status** table lists the current status and configuration of all interfaces.* **Name** – The interface's name (e.g., lan, wan1).
* **Supports Outside** – Indicates if the interface can handle WAN traffic.
* **Status** – Displays whether the interface is active (Up) or inactive (Down).
* **MTU** – The Maximum Transmission Unit size in bytes which is 1500 bytes.
* **HW Address** – The hardware (MAC) address of the interface.
* **IP** – The IP address assigned to the interface.